True/False Indicate whether the statement is
true or false.
|
|
1.
|
The same connector can be used with epoxy, anaerobic or Hot Melt
adhesives.
|
|
2.
|
Singlemode and multimode connectors use different polishing techniques.
|
|
3.
|
“Air Polishing” is needed to remove most of the fiber stub left
after cleaving the fiber near the connector ferrule end.
|
|
4.
|
Polishing the connector ferrule end too much can be just as bad as not polishing
enough.
|
|
5.
|
Anaerobic adhesive can be used for termination with or without an
“accellerator” chemical which reduces curing time but decreases adhesive strength.
|
|
6.
|
A Hot Melt oven can be used for curing epoxy also.
|
Multiple Choice Identify the choice that best
completes the statement or answers the question.
|
|
7.
|
When you strip a fiber to prepare it for termination, you remove the
______.
a. | Core | b. | Cladding | c. | Primary buffer
coating | d. | Dirt and contamination |
|
|
8.
|
When adhesive is in the connector and you are ready to insert the fiber into the
connector, you should _________.
a. | Hold the connector vertically | b. | Remove the dust cap | c. | Clean the
fiber | d. | Check the fiber length |
|
|
9.
|
The polishing films for final polish should be placed on _______.
a. | The workbench surface | b. | A flat glass or plastic
plate | c. | A ~3mm hard rubber pad | d. | A stack of old polishing
film |
|
|
10.
|
For most multimode connectors, small scratches are not a problem if they are not
on the ______.
a. | Core | b. | Cladding | c. | Ferrule | d. | End of the
ferrule |
|
Multiple Response Identify one or more choices
that best complete the statement or answer the question.
|
|
11.
|
When terminating fiber optic connectors, you need to _________ to ensure safety.
(Check all that apply)
|
|
12.
|
To obtain low loss with a prepolished/splice connector with a mechanical splice,
it is necessary to _________.(Check all that apply)
|